FRONT STABILIZER BAR(for AWD) INSTALLATION

PROCEDURE


  1. INSTALL FRONT STABILIZER BAR


    1. B004WVMN01

      Install the front stabilizer bar with the 4 bolts.

      Torque:
      120 N*m  { 1224 kgf*cm, 89 ft.*lbf }

      Note

      Temporarily tighten the bolt (A), and then fully tighten the 4 bolts in the order of (B), (C), (D), and (A).

  2. INSTALL FRONT STABILIZER LINK ASSEMBLY LH


    1. Install the front stabilizer link assembly LH to the lower No. 2 suspension arm assembly LH and front stabilizer bar with the 2 nuts.

      Torque:
      150 N*m  { 1530 kgf*cm, 111 ft.*lbf }

      Tech Tips

      If the ball joint turns together with the nut, use a 8 mm hexagon wrench to hold the stud bolt.

  3. INSTALL FRONT STABILIZER LINK ASSEMBLY RH

    Tech Tips

    Perform the same procedure as for the LH side.

  4. INSTALL STRUT BAR BRACKET SUPPORT SUB-ASSEMBLY

    Click here

  5. INSTALL FRONT SUSPENSION MEMBER BRACE

    Click here

  6. INSTALL NO.2 ENGINE UNDER COVER ASSEMBLY

    Click here

  7. INSTALL NO.1 ENGINE UNDER COVER ASSEMBLY

    Click here

  8. INSTALL FRONT WHEEL

    Click here