RELAY INSPECTION

PROCEDURE


  1. INSPECT SUSPENSION CONTROL RELAY


    1. Remove the suspension control relay.

    2. Check the relay case and the terminal for deformation and corrosion.

      Standard
      No deformation or corrosion.
    3. B004TSHN01

      Measure the resistance according to the value(s) in the table below.

      Standard resistance
      Tester Connection Condition Specified Condition
      3 - 5 Battery voltage is not applied to terminals 1 and 2 10 kΩ or higher
      Battery voltage is applied to terminals 1 and 2 Below 1 Ω

      If the result is not as specified, replace the suspension control relay.

    4. Install the suspension control relay.