LUGGAGE DOOR OPENING SWITCH INSPECTION

PROCEDURE

1. Click here

   INSPECT TRUNK AND FUEL SWITCH ASSEMBLY

   
   
   1. 

      *a	Component without harness connected (Trunk and Fuel Switch Assembly)

      Check the resistance.

      
      

      1. Measure the resistance according to the value(s) in the table below.

         Standard Resistance
         Tester Connection Switch Condition Specified Condition G73-4(B) - G73-3(L) Switch on Below 1 Ω G73-4(B) - G73-3(L) Switch off 10 kΩ or higher

         Tip:

         If the result is not as specified, replace the trunk and fuel switch assembly.

   2. Inspect the illumination operation.

      
      

      1. Apply auxiliary battery voltage to the trunk and fuel switch assembly connector, and check that the trunk and fuel switch assembly LED illuminates.

         OK
         Tester Connection Specified Condition G73-1 (ILL+) - Auxiliary battery positive (+) G73-5 (ILL-) - Auxiliary battery negative (-) LED illuminates

         Tip:

         If the result is not as specified, replace the trunk and fuel switch assembly.