POWER TRUNK LID SYSTEM INITIALIZATION


  1. INITIALIZE LUGGAGE CLOSER MOTOR ASSEMBLY

    Note

    Initialization of the luggage closer motor assembly (luggage compartment door initial position learning) is necessary if the following work procedures are performed while the luggage compartment door is open.


    • The cable to the negative (-) auxiliary battery terminal is connected.

    • A power source system fuse of the power trunk lid system is disconnected and reconnected.

    • The luggage closer motor assembly is replaced or the connectors are disconnected.

    • When the luggage compartment door is opened using a mechanical key.

    The power back door does not operate unless the luggage closer motor assembly is initialized.

    Tech Tips


    • Initialization is not necessary if the above procedures are performed while the luggage compartment door is closed.

    • When disconnecting the negative (-) auxiliary battery terminal, some systems need to be initialized after the negative (-) auxiliary battery terminal is reconnected.

      Click here


    1. Initialization operation


      1. Fully close the luggage compartment door by hand.