Click here

FUEL LID OPENER SYSTEM(w/ Canister Pump Module) DATA LIST / ACTIVE TEST

Click here
Click here
Click here

  1. DATA LIST

    Tip:

    Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    Note:

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


    1. Turn the power switch off.

    2. Connect the GTS to the DLC3.

    3. Turn the power switch on (IG).

    4. Turn the GTS on.

    5. Enter the following menus: Powertrain / Engine / Data List.

    6. According to the display on the GTS, read the "Data List".


      1. Powertrain > Engine > Data List
        Tester Display Measurement Item Range Normal Condition Diagnostic Note
        Fuel Filler Opener Fuel lid with motor lock assembly status OFF or ON

        OFF: Fuel lid with motor lock assembly not operating

        ON: Fuel lid with motor lock assembly operating

        		 -
        Fuel Lid SW Trunk and fuel switch assembly (fuel lid opener switch) status Close or Open

        Close: Trunk and fuel switch assembly (fuel lid opener switch) not pushed

        Open: Trunk and fuel switch assembly (fuel lid opener switch) pushed

        		 -
        Fuel Lid Sensor SW Fuel lid with motor lock assembly (fuel lid courtesy switch) status Close or Open

        Close: Fuel lid closed

        Open: Fuel lid open

        		 -




  2. ACTIVE TEST

    Tip:

    Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


    1. Turn the power switch off.

    2. Connect the GTS to the DLC3.

    3. Turn the power switch on (IG).

    4. Turn the GTS on.

    5. Enter the following menus: Powertrain / Engine / Active Test.

    6. According to the display on GTS perform the "Active Test".


      1. Powertrain > Engine > Active Test
        Tester Display Measurement Item Control Range Diagnostic Note
        Activate the Fuel Filler Opener Activate fuel lid with motor lock assembly (fuel lid motor) OFF or ON -