Click here

POWER TRUNK LID SYSTEM DATA LIST / ACTIVE TEST

Click here
Click here
Click here

  1. DATA LIST

    Note:

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

    Tip:

    Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


    1. Turn the power switch off.

    2. Connect the GTS to the DLC3.

    3. Turn the power switch on (IG).

    4. Turn the GTS on.

    5. Enter the following menus: Body Electrical / Main Body or Back Door / Data List.

    6. Read the Data List according to the display on the GTS.


      1. Body Electrical > Main Body > Data List
        Tester Display Measurement Item Range Normal Condition Diagnostic Note
        Trunk Lock Position Luggage compartment door lock signal Lock or Unlock

        Lock: Luggage door closer assembly locked

        Unlock: Luggage door closer assembly unlocked

        		 -
        Trunk/BDoor Open SW Trunk and fuel switch assembly (luggage door opening switch) signal OFF or ON

        OFF: Trunk and fuel switch assembly (luggage door opening switch) off

        ON: Trunk and fuel switch assembly (luggage door opening switch) on

        		 -
        Trunk Main SW Luggage door opening cancel switch assembly signal OFF or ON

        OFF: Luggage door opening cancel switch assembly off

        ON: Luggage door opening cancel switch assembly on

        		 -
        Trunk Link with Door Lock Function that opens the luggage compartment door when the electrical key transmitter sub-assembly is not being carried and the luggage electrical key switch is pressed and all doors are unlocked using the entry door lock function, wireless door lock function, mechanical key or door control switch. OFF or ON Customized value displayed -






      1. Body Electrical > Back Door > Data List
        Tester Display Measurement Item Range Normal Condition Diagnostic Note
        Half Latch SW Luggage closer motor assembly (half latch switch) signal OFF or ON

        ON: Luggage door closer assembly open-latched

        OFF: Luggage door closer assembly full-latched or half-latched

        		 -
        Pawl Position Switch Luggage closer motor assembly (pawl switch) signal OFF or ON

        ON: Luggage door closer assembly open-latched

        OFF: Luggage door closer assembly except open-latched

        		 -
        PBD Close SW Door control switch signal OFF or ON

        OFF: Door control switch off

        ON: Door control switch on

        		 -
        IG SW Power switch signal OFF or ON

        OFF: Power switch off

        ON: Power switch on (IG)

        		 "OFF" is also displayed for this item when the power switch on (ACC).
        PBD Position (3/4-Open) Luggage compartment door position (3/4 open - Full open) Caution or OK

        Caution: Luggage compartment door position is not 3/4 opened - fully opened

        OK: Luggage compartment door position is 3/4 opened - fully opened

        		 -
        PBD Position (2/4-3/4) Luggage compartment door position (Full close - 3/4 open) Caution or OK

        Caution: Luggage compartment door position is not 2/4 opened - 3/4 opened

        OK: Luggage compartment door position is 2/4 opened - 3/4 opened

        		 -
        PBD Position (1/4-2/4) Luggage compartment door position (Full close - 2/4 open) Caution or OK

        Caution: Luggage compartment door position is not 1/4 opened - 2/4 opened

        OK: Luggage compartment door position is 1/4 opened - 2/4 opened

        		 -
        PBD Position (Close-1/4) Luggage compartment door position (Full close - 1/4 open) Caution or OK

        Caution: Luggage compartment door position is not fully closed - 1/4 opened

        OK: Luggage compartment door position is fully closed - 1/4 opened

        		 -
        Closed Position Initialization Status of luggage compartment door fully closed position memorized signal Not Initialized or Initialized

        Not Initialized: Back door fully closed position not memorized

        Initialized: Back door fully closed position memorized

        		 When "Not initialized is displayed for this item, power trunk lid system is not operated.
        PBD Power Operation Status of the power trunk lid and luggage compartment door closer setting OFF, ON(Closer Only) or ON Customized value displayed -
        Kick Sensor Connection Status of the kick door control sensor connection* Without or With

        Without: kick door control sensor not equipped

        With: kick door control sensor equipped

        		 When checking this item, disconnect the negative (-) battery terminal, wait 1 minute or more, and then reconnect the negative (-) battery terminal with the connectors of the luggage closer motor assembly and kick door control sensor connected.
        Kick Sensor Detection Status of the kick door control sensor detection* OFF or ON

        OFF: Kick door control sensor not detecting a foot

        ON: Kick door control sensor detecting a foot

        		 -
        Kick Sensor Error Status of the kick door control sensor error* Normal or Error

        Normal: Kick door control sensor is normal

        Error: Kick door control sensor is abnormal

        		 -
        Kick Sensor Function Status of the hands free power trunk lid function* OFF or ON Customized value displayed -
        #Codes Number of trouble codes 0 to 255 Number of DTCs will be displayed -

















      • *: w/ Hands Free Power Trunk Lid

  2. ACTIVE TEST

    Tip:

    Using the GTS to perform the Active Tests allows relays, VSVs and actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


    1. Turn the power switch off.

    2. Connect the GTS to the DLC3.

    3. Turn the power switch on (IG).

    4. Turn the GTS on.

    5. Enter the following menus: Body Electrical / Main Body or Back Door / Active Test.

    6. Perform the Active Test according to the display on the GTS.


      1. Body Electrical > Main Body > Active Test
        Tester Display Measurement Item Control Range Diagnostic Note
        Trunk and Back-Door Open Operate luggage door closer assembly latch release OFF or ON Not applicable



      1. Body Electrical > Back Door > Active Test
        Tester Display Measurement Item Control Range Diagnostic Note
        Latch Release Latch release operation OFF or ON -
        PBD Motor luggage closer motor operation OFF, Forward or Reverse -
        PBD Clutch Clutch operation OFF or ON -
        PBD Buzzer Warning buzzer sound OFF or ON -
        PBD Close SW Light Operate luggage compartment door closer switch light OFF or ON -