SLIDING ROOF HOUSING DISASSEMBLY

PROCEDURE


  1. REMOVE NO. 2 SLIDING ROOF HOUSING PAD


    1. B004TK5

      Remove the 2 screws.

    2. Detach the guide as shown in the illustration to remove the map light bracket.

    3. B004XHA

      Remove the No. 2 sliding roof housing pad.

  2. REMOVE SLIDING ROOF HOUSING PAD


    1. B004WH2

      Remove the sliding roof housing pad.

  3. REMOVE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY


    1. B004UUI

      Remove the 2 bolts and sliding roof drive gear sub-assembly.

  4. REMOVE SUNSHADE TRIM SUB-ASSEMBLY


    1. Detach the claw in the direction indicated by the arrow (1) shown in the illustration.

      B004RKOC01
      *a Claw *b Guide
      B004RMI Remove in this Direction (1) B004T3S Remove in this Direction (2)

    2. Detach the guide in the direction indicated by the arrow (2) shown in the illustration to remove the sliding roof channel.

      Tech Tips

      Use the same procedure for the RH side.

    3. B004TNLC01
      B004RMI Remove in this Direction

      Remove the rear sliding roof sunshade stopper as shown in the illustration.

      Tech Tips

      Use the same procedure for the RH side.

    4. B004VT3C01
      B004RMI Remove in this Direction

      Remove the sunshade trim sub-assembly as shown in the illustration.

  5. REMOVE ROOF WIND DEFLECTOR PANEL SUB-ASSEMBLY

    Note

    Do not disassemble the roof wind deflector panel sub-assembly except when replacing it.


    1. B004T73C01
      B004V32 Hold Position

      Hold the roof wind deflector panel sub-assembly until the sliding roof drive cable sub-assembly goes over the roof wind deflector panel sub-assembly.

    2. Using a screwdriver, slide the roof wind deflector panel sub-assembly forward in the vehicle and release the lock.

      B004WQLC01
      *a Protective Tape - -
      B004RMI Slide in this Direction B004T3S Unlock

      Tech Tips


      • Tape the screwdriver tip before use.

      • Use the same procedure for the RH side.

    3. B004YUWC01
      *a Protective Tape
      B004RMI Slide in this Direction

      Using a screwdriver, slide the roof wind deflector panel sub-assembly toward the rear of the vehicle as shown in the illustration.

      Tech Tips


      • Tape the screwdriver tip before use.

      • Use the same procedure for the RH side.

    4. Pull the roof wind deflector panel sub-assembly in the direction indicated by the arrow (1) shown in the illustration.

      B004UMTC01
      B004RMI Remove in this Direction (1) B004T3S Remove in this Direction (2)

    5. Detach the claw and remove the roof wind deflector panel sub-assembly in the direction indicated by the arrow (2) shown in the illustration.