SLIDING ROOF SYSTEM, Diagnostic DTC:B2342

DESCRIPTION

This DTC is stored when the sliding roof drive gear sub-assembly (sliding roof ECU) detects that the map light sub-assembly (slide roof switch) is stuck for 30 seconds or more.

CAUTION / NOTICE / HINT

PROCEDURE

1. Click here

   READ VALUE USING GTS (Switch Failure)

   
   

   1. Read the Data List according to the display on the GTS.

      Click here

      
      
      1. Body Electrical > Sliding Roof > Data List

         Tester Display	Measurement Item	Range	Normal Condition	Diagnostic Note
         Open Switch Failure(Past)	OPEN switch failure signal (Past)	OFF or ON	OFF: No OPEN switch failure signal (Past) ON: OPEN switch failure signal (Past)	-
         Close Switch Failure(Past)	CLOSE switch failure signal (Past)	OFF or ON	OFF: No CLOSE switch failure signal (Past) ON: CLOSE switch failure signal (Past)	-
         Up Switch Failure(Past)	UP switch failure signal (Past)	OFF or ON	OFF: No UP switch failure signal (Past) ON: UP switch failure signal (Past)	-
         Down Switch Failure(Past)	DOWN switch failure signal (Past)	OFF or ON	OFF: No DOWN switch failure signal (Past) ON: DOWN switch failure signal (Past)	-
         Open Switch Failure(Current)	OPEN switch failure signal (Current)	OFF or ON	OFF: No OPEN switch failure signal (Current) ON: OPEN switch failure signal (Current)	-
         Close Switch Failure(Current)	CLOSE switch failure signal (Current)	OFF or ON	OFF: No CLOSE switch failure signal (Current) ON: CLOSE switch failure signal (Current)	-
         Up Switch Failure(Current)	UP switch failure signal (Current)	OFF or ON	OFF: No UP switch failure signal (Current) ON: UP switch failure signal (Current)	-
         Down Switch Failure(Current)	DOWN switch failure signal (Current)	OFF or ON	OFF: No DOWN switch failure signal (Current) ON: DOWN switch failure signal (Current)	-

      2. 
         
         10. 
             
         11. 
             
         12. 
             
         13. 
             
         14. 
             
         15. 
             
         16. 
             
         17. 
             
      
      
      1. Body Electrical > Sliding Roof > Data List

         Tester Display
         Open Switch Failure(Past)
         Close Switch Failure(Past)
         Up Switch Failure(Past)
         Down Switch Failure(Past)
         Open Switch Failure(Current)
         Close Switch Failure(Current)
         Up Switch Failure(Current)
         Down Switch Failure(Current)

      2. 
         
         1. 
            
      3. 
         
         10. 
             
         11. 
             
         12. 
             
         13. 
             
         14. 
             
         15. 
             
         16. 
             
         17. 
             

      OK
      OFF appears on the GTS screen.

      Result
      Result Proceed to All items are displayed "OFF" A In part or in whole item displayed "ON" B

   
   
   • A

     REPLACE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLYClick here

   • BClick here
2. Click here

   INSPECT MAP LIGHT SUB-ASSEMBLY

   
   

   1. Remove the map light sub-assembly (slide roof switch).

      Click here

   2. Inspect the map light sub-assembly (slide roof switch).

      Click here

      Result
      Proceed to OK NG

   
   
   • OKClick here
   • NG

     REPLACE MAP LIGHT SUB-ASSEMBLYClick here

3. Click here

   CHECK HARNESS AND CONNECTOR (SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY - MAP LIGHT SUB-ASSEMBLY AND BODY GROUND)

   
   

   1. Disconnect the N4 sliding roof drive gear sub-assembly connector.

   2. Disconnect the N7 and N9 map light sub-assembly connectors.

   3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition N4-10 (OPN) - N9-12 (OPN) Always Below 1 Ω N4-8 (CLS) - N9-14 (CLS) Always Below 1 Ω N4-9 (DWN) - N9-16 (DOWN) Always Below 1 Ω N4-5 (UP) - N9-15 (UP) Always Below 1 Ω N4-2 (E) - Body ground Always Below 1 Ω N7-22 (GND) - Body ground Always Below 1 Ω N4-10 (OPN) or N9-12 (OPN) - Body ground Always 10 kΩ or higher N4-8 (CLS) or N9-14 (CLS) - Body ground Always 10 kΩ or higher N4-9 (DWN) or N9-16 (DOWN) - Body ground Always 10 kΩ or higher N4-5 (UP) or N9-15 (UP) - Body ground Always 10 kΩ or higher

      Result
      Proceed to OK NG

   
   
   • OK

     REPLACE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLYClick here

   • NG

     REPAIR OR REPLACE HARNESS OR CONNECTOR