POWER WINDOW MASTER SWITCH REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure as for the LHD and RHD vehicles.

  • The procedure listed below is for the LHD vehicles.

PROCEDURE


  1. REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY


    1. B004RBSC01
      B004RMI Remove in this Direction (1)
      B004T3S Remove in this Direction (2)

      Using moulding remover A, pull in the direction of the arrow (1) shown in the illustration to detach the claw.

    2. Pull in the direction of the arrow (2) shown in the illustration and remove the multiplex network master switch assembly from the front door trim board sub-assembly LH.

      Note

      Do not damage the armrest.

    3. Disconnect the connector.

    4. B004VKO

      Using moulding remover A, detach the claw and remove the multiplex network master switch assembly from the front door armrest upper base panel.