| DTC Code | DTC Name |
|---|---|
| Front Passenger Side Power Window does not Operate with Front Passenger Side Power Window Switch |
DESCRIPTION
When the power switch is on (IG), the front power window regulator motor assembly RH (for LHD) or front power window regulator motor assembly LH (for RHD) is operated by the power window regulator switch assembly. The front power window regulator motor assembly RH (for LHD) or front power window regulator motor assembly LH (for RHD) has motor, regulator and ECU functions.
CAUTION / NOTICE / HINT
The power window control system uses the LIN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Troubleshoot the power window control system after confirming that the communication system is functioning properly.
If the front power window regulator motor assembly RH (for LHD) or front power window regulator motor assembly LH (for RHD) has been replaced with a new one, initialize the power window control system.
Check that the window lock switch is off before performing the following procedure.
Inspect the fuses for circuits related to this system before performing the following procedure.
PROCEDURE
READ VALUE USING GTS (P-DOOR MOTOR)
Using the GTS, read the data for the condition when the power window regulator switch assembly was operated.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| P Door P/W Up SW | Front passenger door power window manual up switch signal | OFF or ON | OFF: Front passenger door power window manual up switch not being operated ON: Front passenger door power window manual up switch being operated |
- |
| P Door P/W Down SW | Front passenger door power window manual down switch signal | OFF or ON | OFF: Front passenger door power window manual down switch not being operated ON: Front passenger door power window manual down switch being operated |
- |
| Tester Display |
|---|
| P Door P/W Up SW |
| P Door P/W Down SW |
| OK |
|---|
| On the GTS screen, ON or OFF is displayed accordingly. |
| Result | ||||||||
|---|---|---|---|---|---|---|---|---|
|
REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RHClick here
REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LHClick here
INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY
Remove the power window regulator switch assembly.
Inspect the power window regulator switch assembly.
| Result | |||
|---|---|---|---|
|
REPLACE POWER WINDOW REGULATOR SWITCH ASSEMBLYClick here
CHECK HARNESS AND CONNECTOR (POWER WINDOW REGULATOR SWITCH ASSEMBLY - FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH)
*1: for LHD
*2: for RHD
Disconnect the I1*1 or I4*2 power window regulator switch assembly connector.
Disconnect the H2*1 or H21*2 front power window regulator motor assembly connector.
Measure the resistance according to the value(s) in the table below.
| Standard Resistance | |||||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I4-2 (UP) - H21-10 (UP) | Always | Below 1 Ω |
| I4-10 (DOWN) - H21-7 (DOWN) | Always | Below 1 Ω |
| I4-4 (AUTO) - H21-4 (AUTO) | Always | Below 1 Ω |
| I4-2 (UP) or H21-10 (UP) - Body ground | Always | 10 kΩ or higher |
| I4-10 (DOWN) or H21-7 (DOWN) - Body ground | Always | 10 kΩ or higher |
| I4-4 (AUTO) or H21-4 (AUTO) - Body ground | Always | 10 kΩ or higher |
| Result | ||||||||
|---|---|---|---|---|---|---|---|---|
|
REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RHClick here
REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LHClick here
REPAIR OR REPLACE HARNESS OR CONNECTOR