REAR SUNSHADE SWITCH(for Rear Side) INSPECTION

PROCEDURE


  1. INSPECT REAR POWER SEAT SWITCH (REAR SUNSHADE SWITCH)


    1. B004VKNC01
      *1 Rear Sunshade Switch
      *a

      Component without harness connected

      (Rear Power Seat Switch (Rear Sunshade Switch))

      Check the resistance.

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      9 (ECU) - 13 (E) Rear sunshade switch ON Below 1 Ω
      Rear sunshade switch OFF 10 kΩ or higher

      If the result is not as specified, replace the power seat switch (rear sunshade switch)

    2. B004VKNC02
      *a

      Component without harness connected

      (Rear Power Seat Switch (Rear Sunshade Switch))

      Check illumination.

      Apply auxiliary battery voltage to the trip switch (light control rheostat) and check that it illuminates.

      OK
      Tester Connection Specified Condition

      6 (ILL+) - Auxiliary battery positive (+)

      11 (ILL-) - Auxiliary battery negative (-)

      		 Illuminates

      If the result is not as specified, replace the power seat switch (rear sunshade switch)