Click here

REAR MULTI OPERATION PANEL SYSTEM DATA LIST / ACTIVE TEST

Click here
Click here
Click here

  1. DATA LIST

    Note:

    In the following table, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

    Tip:

    Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Rear Console Switch / Data List.

    5. Read the Data List according to the display on the GTS.


      1. Body Electrical > Rear Console Switch > Data List
        Tester Display Range Normal Condition Diagnostic Note
        Communication Air Conditioner ECU With or Without

        With: Connected to air conditioning amplifier assembly

        Without: Not connected to air conditioning amplifier assembly

        		 -
        Communication EMV (CAN) With or Without

        With: Connected to radio receiver assembly

        Without:Not connected to radio receiver assembly

        		 -
        Communication RSE With or Without

        With: Connected to multi-display controller sub-assembly

        Without: Not connected to multi-display controller sub-assembly

        		 -
        Hard Switch State OFF or ON

        OFF: Home switch released

        ON: Home switch pressed

        		 -
        Rear Shade Switch State OFF or ON

        OFF: Rear window sunshade switch released

        ON: Rear window sunshade switch pressed

        		 -
        Rear Armrest Close State Close or Open

        Close: Rear seat armrest center closed

        Open: Rear seat armrest center open

        		 -
        Communication RR Seat WITH or WITHOUT

        WITH: Connected to position control ECU assembly RH

        WITHOUT: Not connected to position control ECU assembly RH

        		 Even if the items on the left are displayed on the GTS, they are not supported for this vehicle.
        Communication RL Seat WITH or WITHOUT

        WITH: Connected to position control ECU assembly LH

        WITHOUT: Not connected to position control ECU assembly LH

        		 Even if the items on the left are displayed on the GTS, they are not supported for this vehicle.
        Number of Trouble Codes Min.: 0, Max.: 255 The number of the DTC currently stored -










  2. ACTIVE TEST

    Tip:

    Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Rear Console Switch / Active Test.

    5. Perform the Active Test according to the display on the GTS.


      1. Body Electrical > Rear Console Switch > Active Test
        Tester Display Measurement Item Control Range Diagnostic Note
        Hard Switch Lighting Illuminates the home switch light OFF or ON -