REAR SUNSHADE SYSTEM DATA LIST / ACTIVE TEST


  1. DATA LIST

    Note

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

    Tech Tips

    Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus:


      • Body Electrical / Main Body / Data List.

      • Body Electrical / Rear Console Switch / Data List.

    5. Read the Data List according to the display on the GTS.


      Body Electrical > Main Body > Data List
      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      Rear Shade Delay Time Function to adjust reverse-linked sunshade lowering function's response time 0.7 s, 1.2 s, 0.9 s or 0.0 s Customized value displayed -
      R-pos to Rear Sun Shade COM Reverse linked function ON or OFF Customized value displayed -

      Body Electrical > Rear Console Switch > Data List
      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      Rear Shade Switch State Rear sunshade switch of the rear power seat switch condition OFF or ON

      OFF: Rear sunshade switch off

      ON: Rear sunshade switch on

      		 w/ Rear Multi Operation Panel System

  2. ACTIVE TEST

    Tech Tips

    Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Main Body / Active Test.

    5. Perform the Active Test according to the display on the GTS.


      Body Electrical > Main Body > Active Test
      Tester Display Measurement Item Control Range Diagnostic Note
      Reverse Gear Signal Reverse signal OFF/ON -