REAR MULTI OPERATION PANEL SYSTEM Power Source Circuit

DESCRIPTION

This circuit is the power source circuit for the rear power seat switch (rear multi operation panel).

WIRING DIAGRAM

CAUTION / NOTICE / HINT

PROCEDURE

1. Click here

   CHECK HARNESS AND CONNECTOR (REAR SEAT ARMREST ASSEMBLY CENTER - BATTERY [+B, IGN] AND BODY GROUND)

   
   

   1. Disconnect the L80 rear seat armrest assembly center connector.

   2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Switch Condition Specified Condition L80-17 (B) - Body ground Power switch off 11 to 14 V L80-6 (ACC) - Body ground Power switch on (ACC) 11 to 14 V

   3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition L80-1 (E) - Body ground Always Below 1 Ω

      Result
      Proceed to OK NG

   
   
   • OKClick here
   • NG

     REPAIR OR REPLACE HARNESS OR CONNECTOR

2. Click here

   CHECK REAR SEAT ARMREST ASSEMBLY CENTER

   
   
   1. 

      *a	Front view of rear seat armrest assembly center wire harness connector (to Rear Power Seat Switch [Rear Multi Operation Panel])

      Disconnect the rear power seat switch (rear multi operation panel) connector.

   2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Switch Condition Specified Condition A-12 (B) - Body ground Power switch off 11 to 14 V A-6 (ACC) - Body ground Power switch on (ACC) 11 to 14 V

   3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Switch Condition Specified Condition A-1 (E) - Body ground Always Below 1 Ω

      Result
      Proceed to OK NG

   
   
   • OK

     PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLEClick here

   • NG

     REPLACE REAR SEAT ARMREST ASSEMBLY CENTERClick here