CAUTION / NOTICE / HINT
-
Use the same procedure for RHD and LHD vehicles.
-
The procedure listed below is for LHD vehicles.
PROCEDURE
- Click here
INSTALL AIR CONDITIONER PRESSURE SENSOR
-
Remove the attached vinyl tape from the air conditioner pressure sensor installation area of the liquid tube sub-assembly A.
-
Apply a sufficient amount of compressor oil to the fitting surface of a new air conditioner pressure sensor O-ring and the liquid tube sub-assembly A.
Compressor Oil ND-OIL 11 or equivalent Note:
-
Do not use any compressor oil other than ND-OIL 11 or equivalent. If any compressor oil other than ND-OIL 11 or equivalent is used, compressor motor insulation performance may decrease, resulting in leakage of electric power.
-
Keep the O-ring and O-ring fitting surface free of foreign matter.
-
-
*a Turn *b Hold 
Install in this Direction Using a 27 mm deep socket wrench, install the air conditioner pressure sensor to the liquid tube sub-assembly A.
10.8 N*m 110 kgf*cm 8 ft.*lbf Note:
-
Do not apply excessive force to the liquid tube sub-assembly A.
-
Make sure not to cut the O-ring while installing it. (Cut O-rings cannot be installed)
-
-
No. 2 Cooler Cover 
Connector Install the No. 2 cooler cover.
-
Connect the connector.
-
- Click here
INSTALL LOWER ARM BRACKET BRACE SUB-ASSEMBLY LH
- Click here
INSTALL LOW PITCHED HORN ASSEMBLY
- Click here
INSTALL HOOD LOCK RELEASE LEVER PROTECTOR
- Click here
INSTALL FRONT BUMPER ASSEMBLY
-
for Sport Package:
-
except Sport Package:
-
- Click here
CHARGE AIR CONDITIONING SYSTEM WITH REFRIGERANT
-
for HFC-134a(R134a):
-
for HFO-1234yf(R1234yf):
-
- Click here
WARM UP COMPRESSOR
-
for HFC-134a(R134a):
-
for HFO-1234yf(R1234yf):
-
- Click here
INSPECT FOR REFRIGERANT LEAK
-
for HFC-134a(R134a):
-
for HFO-1234yf(R1234yf):
-
- Click here
INSTALL LOWER RADIATOR AIR DEFLECTOR
- Click here
INSTALL UPPER RADIATOR SUPPORT SEAL
- Click here
INSTALL RADIATOR COVER PLATE