Click here

PTC HEATER ASSEMBLY INSTALLATION

Click here
Click here

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

Click here

PROCEDURE


  1. Click here

    INSTALL QUICK HEATER ASSEMBLY


    1. B004WUEC01
      *A for LHD
      *B for RHD
      *a Matchmarks
      *b Heater Case Fitting Surface
      *c Quick Heater Claw
      B004RMI Install in this Direction

      Align the matchmark on the quick heater assembly with the matchmark on the heater case as shown in the illustration, insert the quick heater assembly into the heater case and attach the claw.

      Note:
      • B004YRKC01
        *a Element
        *b Fin

        Do not hold the quick heater assembly by the element or fin. Also, do not damage the quick heater assembly.

      • Foul odors may occur due to oil adhering to the quick heater assembly.

      • Firmly push in until a "click" sound is heard.

      • Check that the heights of the claw fitting surface on the heater case and the claw of the quick heater assembly are aligned.

      B004SGKC01
      *A for LHD
      *B for RHD
      *a Screw Insertion Hole
      Tip:

      If the claws of the quick heater assembly are damaged, install the quick heater assembly with screw (90159-60431).

    2. B004UPMC01
      *A for LHD
      *B for RHD
      B004SZX Connector
      B004UK4 Screw

      Install the quick heater assembly with the screw.

    3. Connect the 2 connectors.

      Tip:

      The 2 connectors can be connected in any position (top or bottom).

  2. Click here

    INSTALL STEERING COLUMN ASSEMBLY

    Click here