Click here

FUEL LID OPENER MOTOR ASSEMBLY INSPECTION

Click here
Click here

PROCEDURE


  1. Click here

    INSPECT FUEL LID LOCK WITH MOTOR ASSEMBLY (w/o Canister Pump Module)


    1. B004TGUC01
      *a

      Component without harness connected

      (Fuel Lid Lock with Motor Assembly)

      Check the operation of the fuel lid lock with motor assembly.


      1. Apply auxiliary battery voltage to the fuel lid lock with motor assembly connector, and check that the fuel lid lock with motor assembly operates smoothly as follows.

        OK
        Tester Connection Specified Condition

        L74-1 (+B) - Auxiliary battery positive (+)

        L74-2 (E) - Auxiliary battery negative (-)

        		 Open Operation
        Tip:

        If the result is not as specified, replace the fuel lid lock with motor assembly.

      2. Measure the shaft stroke.

        OK
        Area Lock Condition Specified Condition
        A Fuel Lid Close 17.7 mm (0.697 in.)
        Fuel Lid Open 0.0 mm (0 in.)
  2. Click here

    INSPECT FUEL LID LOCK WITH MOTOR ASSEMBLY (w/ Canister Pump Module)


    1. B004TGUC02
      *a

      Component without harness connected

      (Fuel Lid Lock with Motor Assembly)

      Check the operation of the fuel lid lock with motor assembly.


      1. Apply auxiliary battery voltage to the fuel lid lock with motor assembly connector, and check that the fuel lid lock with motor assembly operates smoothly as follows.

        OK
        Tester Connection Specified Condition

        L74-1 (+B) - Auxiliary battery positive (+)

        L74-2 (E) - Auxiliary battery negative (-)

        		 Open Operation
        Tip:

        If the result is not as specified, replace the fuel lid lock with motor assembly.

      2. Measure the shaft stroke.

        OK
        Area Lock Condition Specified Condition
        A Fuel Lid Close 17.7 mm (0.697 in.)
        Fuel Lid Open 0.0 mm (0 in.)

    2. Check the resistance of the limit switch.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        L74-3 (B) - L74-2 (E) Fuel Lid Open Below 1 Ω
        L74-3 (B) - L74-2 (E) Fuel Lid Close 10 kΩ or higher
        Tip:

        If the result is not as specified, replace the fuel lid lock with motor assembly.