Click here

POWER SWITCH INSPECTION

Click here
Click here

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

Click here

PROCEDURE


  1. Click here

    INSPECT POWER SWITCH


    1. B004Y9YC25
      *a

      Component without harness connected

      (Power Switch)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition

      5 (SS1) - 6 (AGND)

      1 (SS2) - 6 (AGND)

      		 Not pushed 10 kΩ or higher
      Pushed Below 1 Ω

      If the result is not as specified, replace the power switch.

    2. B004Y9YC26
      *a

      Component without harness connected

      (Power Switch)

      Apply battery voltage between the terminals of the power switch, and check the illumination condition of the power switch indicator light.

      OK
      Condition Specified Condition

      Battery positive (+) → Terminal 9 (SWIL)

      Battery negative (-) → Terminal 6 (AGND)

      		 Illuminates
      Tip:

      • If the positive (+) lead and the negative (-) lead are incorrectly connected, the power switch indicator light will not illuminate.

      • If the voltage is too low, the power switch indicator light will not illuminate.

      If the result is not as specified, replace the power switch.