Click here

FUEL PUMP REASSEMBLY

Click here
Click here

CAUTION / NOTICE / HINT

Tip:

Perform "Inspection After Repairs" after replacing the fuel pump.


Click here

PROCEDURE


  1. Click here

    INSTALL FUEL PUMP

    Tip:

    Perform "Inspection After Repairs" after replacing the fuel pump.



    1. B004WFVC04
      *1 O-Ring
      *2 Fuel Pump Spacer

      Apply a light coat of gasoline to a new O-ring, and then install the fuel pump spacer and O-ring to the fuel pump.

    2. Connect the fuel pump harness connector to install the fuel pump harness to the fuel pump.

    3. Install the fuel pump to the fuel suction plate sub-assembly (fuel filter).

      Note:

      Make sure that the O-ring is not cut or pinched during the installation.

  2. Click here

    INSTALL FUEL PUMP FILTER


    1. Attach the claw to connect the fuel pump harness to the fuel pump filter.

      Note:

      Do not damage the fuel pump filter.

    2. Attach the 3 claws to the claw holes to install the fuel pump filter to the fuel suction plate sub-assembly (fuel filter).

      Note:

      Do not damage the fuel suction plate sub-assembly (fuel filter).

  3. Click here

    INSTALL NO. 1 FUEL SUB-TANK


    1. B004TFUC04
      *1 Jet Pump
      *2 O-Ring

      Apply a light coat of gasoline to a new O-ring and install the O-ring to the jet pump.

    2. Install the No. 2 fuel tank cushion to the fuel suction plate sub-assembly (fuel filter), and then install the fuel suction plate sub-assembly (fuel filter) to the No. 1 fuel sub-tank.

      Note:

      Do not damage the No. 1 fuel sub-tank and fuel suction plate sub-assembly (fuel filter).

    3. Attach the 2 claws to install the fuel suction plate sub-assembly (fuel filter) to the No. 1 fuel sub-tank.

      Note:

      Do not damage the No. 1 fuel sub-tank.

    4. Connect the jet pump to the No. 1 fuel sub-tank.

      Note:

      • Make sure that the O-ring is not cut or pinched during the installation.

      • Do not damage the No. 1 fuel sub-tank.

    5. Install a new fuel tank pipe setting holder.

    6. Attach the fuel pump harness clamp.

    7. Connect the 2 fuel pump harness connectors.

  4. Click here

    INSTALL FUEL SENDER GAUGE ASSEMBLY

    Click here