COMBINATION SWITCH INSPECTION

PROCEDURE

1. Click here

   REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY

   Click here

2. Click here

   INSPECT INTEGRATION CONTROL AND PANEL ASSEMBLY (for LHD)

   
   

   1. Inspect EV mode switch (integration control and panel assembly)

      
      
      1. 

         *a	Component without harness connected (Integration Control And Panel Assembly (EV Mode Switch))

         Measure the resistance according to the value(s) in the table below.

         Standard Resistance
         Tester Connection Condition Specified Condition G72-2(S) - G72-8(E) EV mode switch being pushed and held Below 1 Ω EV mode switch not pushed 10 kΩ or higher

         If the result is not as specified, replace the integration control and panel assembly.

   2. Inspect illumination

      
      
      1. 

         *a	Component without harness connected (Integration Control And Panel Assembly (EV Mode Switch))
         *b	Integration Control And Panel Assembly (EV Mode Switch) Illumination

         Apply auxiliary battery voltage between the terminals of the switch, and check the illumination condition of the integration control and panel assembly (EV Mode Switch).

         OK
         Tester Connection Specified Condition Auxiliary Battery positive(+) - G72-5(ILL+) Auxiliary Battery negative(-) - G72-6(ILL-) Illuminates

         If the result is not as specified, replace the integration control and panel assembly.

3. Click here

   INSPECT INTEGRATION CONTROL AND PANEL ASSEMBLY (for RHD)

   
   

   1. Inspect EV mode switch (integration control and panel assembly)

      
      
      1. 

         *a	Component without harness connected (Integration Control And Panel Assembly (EV Mode Switch))

         Measure the resistance according to the value(s) in the table below.

         Standard Resistance
         Tester Connection Condition Specified Condition G72-3(S) - G72-9(E) EV mode switch being pushed and held Below 1 Ω EV mode switch not pushed 10 kΩ or higher

         If the result is not as specified, replace the integration control and panel assembly.

   2. Inspect illumination

      
      
      1. 

         *a	Component without harness connected (Integration Control And Panel Assembly (EV Mode Switch))
         *b	Integration Control And Panel Assembly (EV Mode Switch) Illumination

         Apply auxiliary battery voltage between the terminals of the switch, and check the illumination condition of the integration control and panel assembly (EV Mode Switch).

         OK
         Tester Connection Specified Condition Auxiliary Battery positive(+) - G72-5(ILL+) Auxiliary Battery negative(-) - G72-6(ILL-) Illuminates

         If the result is not as specified, replace the integration control and panel assembly.

4. Click here

   INSTALL INTEGRATION CONTROL AND PANEL ASSEMBLY

   Click here