KNOCK SENSOR INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. Click here

   INSTALL KNOCK CONTROL SENSOR

   Tip:

   Perform "Inspection After Repair" after replacing a knock control sensor.

   
   

   • w/ Canister Pump Module:

     Click here

   • w/o Canister Pump Module:

     Click here

   
   
   1. 

      *A	for Bank 1
      *B	for Bank 2
      *a	View A
      *b	View B
      *c	Top
      *d	Engine Front
      *e	Engine Rear
      	Front
      	View A
      	View B

      Install the 2 knock control sensors with the 2 bolts so that the knock control sensor installation position is as shown in the illustration.

      20 N*m

      204 kgf*cm

      15 ft.*lbf

      Note:
      

      • Make sure that each knock control sensor is in the correct position.

      • If a knock control sensor has been struck or dropped, replace it.

      • Make sure that the knock control sensor is in the correct position.

   2. Connect the 2 knock control sensor connectors.

2. Click here

   INSTALL FUEL INJECTOR ASSEMBLY (for Direct Injection)

   Click here