ENGINE COOLANT TEMPERATURE SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during E.F.I. engine coolant temperature sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
E.F.I. engine coolant temperature sensor Inspection after repair

  • Poor idle, etc.

  • Engine start function, etc.

PROCEDURE


  1. REMOVE INTAKE AIR SURGE TANK ASSEMBLY

    Click here

  2. REMOVE E.F.I. ENGINE COOLANT TEMPERATURE SENSOR


    1. B004RFM

      Disconnect the E.F.I. engine coolant temperature sensor connector.

    2. B004YD2

      Remove the clip and E.F.I. engine coolant temperature sensor from the rear water by-pass joint.