IGNITION COIL AND SPARK PLUG INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. INSTALL SPARK PLUG

   Click here

2. INSTALL IGNITION COIL ASSEMBLY

   Tech Tips

   Perform "Inspection After Repair" after replacing an ignition coil assembly.

   
   

   • w/ Canister Pump Module:

     Click here

   • w/o Canister Pump Module:

     Click here

   
   

   1. for Bank 1:

      
      

      1. Install the 3 ignition coil assemblies with the 3 bolts.

         Torque:

         10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      2. Connect the 3 ignition coil assembly connectors.

   2. for Bank 2:

      
      

      1. Install the 3 ignition coil assemblies with the 3 bolts.

         Torque:

         10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      2. Install the bolt.

         Torque:

         10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      3. Connect the 3 ignition coil assembly connectors.

      4. Install the No. 1 engine cover sub-assembly with clip.

      5. Connect the E.F.I. vacuum sensor connector.

      6. Attach the 2 wire harness clamps.

      7. Install the 2 nuts.

         Torque:

         10 N*m  { 102 kgf*cm, 7 ft.*lbf }

3. INSTALL AIR CLEANER WITH AIR CLEANER HOSE

   Click here

4. CONNECT NO. 2 PCV HOSE

   Click here

5. INSTALL RADIATOR SUPPORT TO CROSS MEMBER BRACE SUB-ASSEMBLY RH

   Click here

6. INSTALL LOWER RADIATOR AIR DEFLECTOR

   Click here

7. INSTALL UPPER RADIATOR SUPPORT SEAL

   Click here

8. INSTALL RADIATOR COVER PLATE

   Click here

9. INSTALL V-BANK COVER SUB-ASSEMBLY

   Click here