CAMSHAFT POSITION SENSOR INSTALLATION

PROCEDURE

1. Click here

   INSTALL VVT SENSOR (for Exhaust Side of Bank 2)

   
   

   1. Apply a light coat of engine oil to the O-ring of the VVT sensor.

      Note:

      If reusing the VVT sensor, be sure to inspect the O-ring.

   2. Install the VVT sensor to the cylinder head cover sub-assembly LH with the bolt.

      10 N*m

      102 kgf*cm

      7 ft.*lbf

      Note:
      

      • If the VVT sensor has been struck or dropped, replace it.

      • Make sure that the O-ring is not cracked or does not move out of place during installation.

   3. Connect the VVT sensor connector.

2. Click here

   INSTALL VVT SENSOR (for Intake Side of Bank 2)

   
   

   1. Apply a light coat of engine oil to the O-ring of the VVT sensor.

      Note:

      If reusing the VVT sensor, be sure to inspect the O-ring.

   2. Install the VVT sensor to the cylinder head cover sub-assembly LH with the bolt.

      10 N*m

      102 kgf*cm

      7 ft.*lbf

      Note:
      

      • If the VVT sensor has been struck or dropped, replace it.

      • Make sure that the O-ring is not cracked or does not move out of place during installation.

   3. Connect the VVT sensor connector.

3. Click here

   INSTALL VVT SENSOR (for Exhaust Side of Bank 1)

   
   

   1. Apply a light coat of engine oil to the O-ring of the VVT sensor.

      Note:

      If reusing the VVT sensor, be sure to inspect the O-ring.

   2. Install the VVT sensor to the cylinder head cover sub-assembly with the bolt.

      10 N*m

      102 kgf*cm

      7 ft.*lbf

      Note:
      

      • If the VVT sensor has been struck or dropped, replace it.

      • Make sure that the O-ring is not cracked or does not move out of place during installation.

   3. Connect the VVT sensor connector.

4. Click here

   INSTALL VVT SENSOR (for Intake Side of Bank 1)

   
   

   1. Apply a light coat of engine oil to the O-ring of the VVT sensor.

      Note:

      If reusing the VVT sensor, be sure to inspect the O-ring.

   2. Install the VVT sensor to the cylinder head cover sub-assembly with the bolt.

      10 N*m

      102 kgf*cm

      7 ft.*lbf

      Note:
      

      • If the VVT sensor has been struck or dropped, replace it.

      • Make sure that the O-ring is not cracked or does not move out of place during installation.

   3. Connect the VVT sensor connector.

5. Click here

   INSTALL AIR CLEANER WITH AIR CLEANER HOSE

   Click here

6. Click here

   CONNECT NO. 2 PCV HOSE

   Click here

7. Click here

   INSTALL LOWER RADIATOR AIR DEFLECTOR

   Click here

8. Click here

   INSTALL UPPER RADIATOR SUPPORT SEAL

   Click here

9. Click here

   INSTALL RADIATOR COVER PLATE

   Click here

10. Click here

    INSTALL V-BANK COVER SUB-ASSEMBLY

    Click here