SUSPENSION CONTROL ECU(for AVS) INSTALLATION

PROCEDURE

1. Click here

   INSTALL ABSORBER CONTROL ECU

   
   

   1. Connect the 2 connectors.

   2. 

      Install the absorber control ECU with the 2 nuts.

      7.5 N*m

      76 kgf*cm

      66 in.*lbf

      Note:
      

      • Avoid any impact to the absorber control ECU.

      • Do not drop the absorber control ECU. If it is dropped, replace it with a new one.

2. Click here

   CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Click here

   Note:
   

   • When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

     Click here

   • After replacing the absorber control ECU, it is necessary to perform registration of vehicle identification information. Vehicle identification information is automatically acquired when the system enters test mode.

     Click here

3. Click here

   INSTALL LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY LH

   Click here

4. Click here

   ADJUST HEADLIGHT ASSEMBLY

   Click here