Click here

FRONT BRAKE FLEXIBLE HOSE(for AWD) REMOVAL

Click here
Click here

CAUTION / NOTICE / HINT

Note:

If both left and right front flexible hoses are disconnected at the same time, be sure to place an identification mark on each hose to indicate its installation position.

Tip:

  • Use the same procedure for the RH and LH side.

  • The following procedure is for the LH side.

Click here

PROCEDURE


  1. Click here

    DISCONNECT BRAKE BOOSTER PUMP CONNECTOR

    Click here

  2. Click here

    REMOVE FRONT WHEEL

    Click here

  3. Click here

    DRAIN BRAKE FLUID

    Note:

    If brake fluid leaks onto any painted surface, immediately wash it off.

  4. Click here

    REMOVE FRONT FLEXIBLE HOSE


    1. B004WHU

      Remove the union bolt and gasket, and disconnect the front flexible hose from the disc brake cylinder assembly LH.

    2. B004SP1

      Remove the 2 bolts, and disconnect the front flexible hose from the front flexible hose bracket LH and No. 2 front flexible hose bracket LH.

    3. B004R2F

      Using a union nut wrench, disconnect the brake tube while holding the front flexible hose with a wrench.

      Note:

      • Do not kink or damage the brake tube.

      • Do not allow any foreign matter such as dirt or dust to enter the brake tube from the connecting parts.

    4. Remove the clip and front flexible hose.