FRONT BRAKE FLEXIBLE HOSE(for 2WD) REMOVAL

CAUTION / NOTICE / HINT

Note

If both left and right front flexible hoses are disconnected at the same time, be sure to place an identification mark on each hose to indicate its installation position.

Tech Tips


  • Use the same procedure for the RH and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. DISCONNECT BRAKE BOOSTER PUMP CONNECTOR

    Click here

  2. REMOVE FRONT WHEEL

    Click here

  3. DRAIN BRAKE FLUID

    Note

    If brake fluid leaks onto any painted surface, immediately wash it off.

  4. REMOVE FRONT FLEXIBLE HOSE


    1. B004Y4U

      Remove the union bolt and gasket, and disconnect the front flexible hose from the disc brake cylinder assembly LH.

    2. B004SQ7

      Remove the bolt and front flexible hose from the front flexible hose bracket LH.

    3. B004W8W

      Using a union nut wrench, disconnect the brake tube while holding the front flexible hose with a wrench.

      Note


      • Do not kink or damage the brake tube.

      • Do not allow any foreign matter such as dirt or dust to enter the brake tube from the connecting parts.

    4. Remove the clip and front flexible hose.