REAR DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL(for AWD) REPLACEMENT

CAUTION / NOTICE / HINT

PROCEDURE

1. Click here

   AIR SUSPENSION CONTROL PROHIBITED (w/ Air Suspension)

   Click here

2. Click here

   DRAIN DIFFERENTIAL OIL

   Click here

3. Click here

   REMOVE REAR DRIVE SHAFT ASSEMBLY LH

   Click here

4. Click here

   REMOVE REAR DRIVE SHAFT OIL SEAL LH

   
   
   1. 

      *1	Rear Drive Shaft Oil Seal LH

      Using SST, remove the rear drive shaft oil seal LH.

      09308-00010

5. Click here

   INSTALL REAR DRIVE SHAFT OIL SEAL LH

   
   
   1. 

      *1	Rear Drive Shaft Oil Seal LH
      *a	Oil Seal Installation Depth

      Using SST and a hammer, install a new rear drive shaft oil seal LH.

      09518-36030
      09950-70010	09951-07150

      Oil seal installation depth
      -0.5 to 0.5 mm (-0.0197 to 0.0196 in.)

      Note:
      

      • Make sure to check the identification marks on the oil seals before installation because the part numbers differ between the left and right sides.

      • To ensure a proper seal, evenly tap in the rear drive shaft oil seal LH.

      • When installing the oil seal, tap it in until its surface is flush with the rear differential carrier.

      • Make sure the difference between the maximum and minimum measured values is less than 0.88 mm (0.0346 in.), as a greater difference may lead to oil leaks.

6. Click here

   INSTALL REAR DRIVE SHAFT ASSEMBLY LH

   Click here

7. Click here

   ADD DIFFERENTIAL OIL

   Click here