STEERING KNUCKLE(for 2WD) INSPECTION

Click here Click here

PROCEDURE

1. Click here

   INSPECT STEERING KNUCKLE

   
   
   1. 

      Temporarily install the nut, and flip the ball joint stud back and forth 5 times as shown in the illustration.

   2. Use a torque wrench to turn the nut continuously at a rate of 3 to 5 seconds per turn. Take the torque reading on the fifth turn.

      Standard turning torque
      0.5 to 6.0 N*m (5 to 61 kgf*cm, 4 to 53 in.*lbf)
      If the value is not within the specified range, replace the steering knuckle with a new one.

   3. Check the dust boot for cracks or grease leakage.