FRONT AXLE HUB(for 2WD) ON-VEHICLE INSPECTION

CAUTION / NOTICE / HINT

Note


  • When the brake pedal is first depressed after replacing the brake pads or pushing back the disc brake piston, DTC C1341, C1342, C1343 and/or C1344 may be stored. As there is no malfunction, clear the DTCs.

  • While the auxiliary battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch is turned on. Therefore, when servicing, do not depress the brake pedal or open/close the doors while the auxiliary battery is connected.

Tech Tips


  • Use the same procedure for the RH and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. AIR SUSPENSION CONTROL PROHIBITED (w/ Air Suspension)

    Click here

  2. DISCONNECT BRAKE BOOSTER PUMP CONNECTOR

    Click here

  3. REMOVE FRONT WHEEL

    Click here

  4. DISCONNECT DISC BRAKE CYLINDER ASSEMBLY


  5. REMOVE FRONT DISC LH


  6. INSPECT FRONT AXLE HUB BEARING LOOSENESS


    1. B004VMY

      Using a dial indicator, check for looseness near the center of the front axle hub sub-assembly.

      Maximum Looseness
      0.05 mm (0.00196 in.)

      Note


      • Ensure that the dial indicator is set perpendicular to the measurement surface.

      • Keep the magnet of the dial indicator away from the front speed sensor.

      Tech Tips

      If the looseness exceeds the maximum, replace the front axle hub sub-assembly.

  7. INSPECT FRONT AXLE HUB RUNOUT


    1. B004XYL

      Using a dial indicator, check for runout on the surface of the front axle hub sub-assembly outside the front axle hub bolts.

      Maximum Runout
      0.05 mm (0.00196 in.)

      Note


      • Ensure that the dial indicator is set perpendicular to the measurement surface.

      • Make sure to set the tip of the dial indicator towards the outside of the front axle hub bolts.

      • Keep the magnet of the dial indicator away from the front speed sensor.

      Tech Tips

      If the runout exceeds the maximum, replace the front axle hub sub-assembly.

  8. INSTALL FRONT DISC LH


  9. CONNECT DISC BRAKE CYLINDER ASSEMBLY


  10. INSTALL FRONT WHEEL

    Click here

  11. CONNECT BRAKE BOOSTER PUMP CONNECTOR

    Click here