Click here

FRONT AXLE HUB BOLT REPLACEMENT

Click here
Click here Click here

CAUTION / NOTICE / HINT

Note:

  • When the brake pedal is first depressed after replacing the brake pads or pushing back the disc brake piston, DTC C1341, C1342, C1343 and/or C1344 may be stored. As there is no malfunction, clear the DTCs.

  • While the auxiliary battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch is turned on. Therefore, when servicing, do not depress the brake pedal or open/close the doors while the auxiliary battery is connected.

Tip:

  • Use the same procedure for the RH and LH side.

  • The following procedure is for the LH side.

Click here

PROCEDURE


  1. Click here

    AIR SUSPENSION CONTROL PROHIBITED (w/ Air Suspension)

    Click here

  2. Click here

    DISCONNECT BRAKE BOOSTER PUMP CONNECTOR

    Click here

  3. Click here

    REMOVE FRONT WHEEL

    Click here

  4. Click here

    DISCONNECT DISC BRAKE CYLINDER ASSEMBLY


  5. Click here

    REMOVE FRONT DISC LH


  6. Click here

    REMOVE FRONT AXLE HUB BOLT


    1. B004RJ6C01
      *a Service Nut
      *b Hold
      *c Turn

      Temporarily install 2 service nuts to the front axle hub bolts as shown in the illustration.

      Recommended Service Nut
      Thread diameter: 14.0 mm (0.551 in.)
      Thread pitch: 1.5 mm (0.0591 in.)
      Note:

      Install the service nuts to prevent damage to the front axle hub bolts.

    2. Using SST and a screwdriver or an equivalent tool to hold the front axle hub, remove the front axle hub bolt.

      09650-17011
      Note:

      Do not damage the threads of the front axle hub bolts.

  7. Click here

    INSTALL FRONT AXLE HUB BOLT


    1. Temporarily install a new front axle hub bolt to the front axle hub.

    2. B004RQJC01
      *a Service Nut
      *b Washer
      *c Hold
      *d Turn

      Install a washer and service nut to a new front axle hub bolt as shown in the illustration.

      Recommended Service Nut
      Thread diameter: 14.0 mm (0.551 in.)
      Thread pitch: 1.5 mm (0.0591 in.)
      Tip:

      Recommended washer thickness is 5 mm (0.197 in.) or more.

    3. Using a screwdriver or an equivalent tool to hold the front axle hub, install the front axle hub bolt by tightening the service nut.

      Note:

      • Install the service nuts to prevent damage to the front axle hub bolts.

      • Do not damage the threads of the front axle hub bolts.

    4. Remove the 3 service nuts and washer from the 3 front axle hub bolts.

  8. Click here

    INSTALL FRONT DISC LH


  9. Click here

    CONNECT DISC BRAKE CYLINDER ASSEMBLY


  10. Click here

    INSTALL FRONT WHEEL

    Click here

  11. Click here

    CONNECT BRAKE BOOSTER PUMP CONNECTOR

    Click here