Click here

REAR DRIVE SHAFT ASSEMBLY INSTALLATION

Click here
Click here Click here

PROCEDURE


  1. Click here

    INSTALL REAR DRIVE SHAFT ASSEMBLY LH


    1. Install a new shaft snap ring.

      Note:

      • Do not damage the spline of the rear drive inboard joint assembly LH.

      • The shaft snap ring should be installed completely.

    2. Coat the spline of the rear drive inboard joint assembly with Toyota genuine differential gear oil LT 75W-85 GL-5 or equivalent.

    3. B004UIQC01
      *a Opening Facing
      *b Press-fit wall

      Align the inboard joint splines, and using a brass bar and a hammer, install the rear drive shaft assembly LH.

      Note:

      • Set the shaft snap ring in the groove with the opening facing downwards and centered radially.

      • Do not damage the oil seal, boot and dust cover.

      • Make sure to follow the proper handling and installation procedures. If the rear drive shaft assembly LH is installed at too large an angle or slides too much, it may fall out of the groove of the joint.

      • Do not tap the end of the rear drive shaft assembly LH with a hammer, etc.

      Tip:

      • Determine whether the rear drive shaft assembly LH is completely tapped in by checking for changes in the tapping sound or the reaction of the brass bar.

      • Use the press-fit wall of the rear drive shaft inboard joint LH when tapping.

  2. Click here

    INSTALL REAR DRIVE SHAFT ASSEMBLY RH

    Tip:

    Use the same procedure as for the LH side.

  3. Click here

    INSTALL REAR AXLE ASSEMBLY LH

    Click here

  4. Click here

    INSTALL REAR AXLE ASSEMBLY RH

    Tip:

    Use the same procedure as for the LH side.

  5. Click here

    INSTALL REAR SUSPENSION MEMBER BRACE LH


    1. Install the rear suspension member brace LH with 2 new bolts.

      25 N*m 255 kgf*cm 18 ft.*lbf
  6. Click here

    INSTALL REAR SUSPENSION MEMBER BRACE RH

    Tip:

    Use the same procedure as for the LH side.

  7. Click here

    INSTALL NO. 2 DIFFERENTIAL SUPPORT PROTECTOR


    1. Install the No. 2 differential support protector with the 3 nuts.

  8. Click here

    INSTALL NO. 1 DIFFERENTIAL SUPPORT PROTECTOR

    Tip:

    Use the same procedure as for the No. 2 differential support protector.