REAR DRIVE SHAFT ASSEMBLY INSPECTION

CAUTION / NOTICE / HINT

Note


  • When using a vise, place aluminum plates between the part and vise.

  • When using a vise, do not overtighten it.

PROCEDURE


  1. INSPECT REAR DRIVE SHAFT ASSEMBLY


    1. B004TWJ

      Check that the inboard joint and outboard joint slides smoothly in the thrust direction.

    2. Check that there is no excessive play in the radial direction of the inboard joint and outboard joint.

    3. Check the inboard joint boot and outboard joint boot for damage.

    4. B004WHJN01

      Check that the inboard joint boot and outboard joint boot are not stretched or contracted when the rear drive shaft assembly is at the standard length.

      Length (A)
      Item Length
      LH Side 2WD 754.0 mm (2.473 ft.)
      AWD 752.0 mm (2.467 ft.)
      RH Side 2WD 708.0 mm (2.322 ft.)
      AWD 707.0 mm (2.318 ft.)

      Note

      Keep the rear drive shaft assembly level during inspection.

      If the inboard joint boot and outboard joint boot are stretched or contracted, correct them.