Click here

FRONT DRIVE SHAFT ASSEMBLY INSPECTION

Click here
Click here Click here

CAUTION / NOTICE / HINT

Note:

  • When using a vise, place aluminum plates between the part and vise.

  • When using a vise, do not overtighten it.

Click here

PROCEDURE


  1. Click here

    INSPECT FRONT DRIVE SHAFT ASSEMBLY


    1. B004U49

      Check that there is no excessive play in the radial direction of the inboard joint and outboard joint.

    2. Check that the inboard joint slides smoothly in the thrust direction.

    3. Check that there is no excessive play in the radial direction of the inboard joint.

    4. Check that the inboard joint boot and outboard joint boot are not cracked or damaged, and no grease is leaking out.

    5. B004Y5QN06

      Check that the inboard joint boot and outboard joint boot are not stretched or contracted when the front drive shaft assembly is at the standard length.

      Length (A)
      Item Length
      for LH Side 536.6 mm (1.76 ft.)
      for RH Side 950.1 mm (3.11 ft.)
      Note:

      Keep the front drive shaft assembly level during inspection.

      If the inboard joint boot and outboard joint boot are stretched or contracted, correct them.