TRANSFER OIL ON-VEHICLE INSPECTION

PROCEDURE

1. Click here

   AIR SUSPENSION CONTROL PROHIBITED (w/ Air Suspension)

   Click here

2. Click here

   INSPECT TRANSFER OIL

   
   
   1. 

      Using a 10 mm hexagon wrench, remove the transfer filler plug and transfer filler plug gasket.

   2. 

      *a	0 to 5.0 mm (0 to 0.196 in.)

      Check that the oil level is between 0 to 5.0 mm (0 to 0.196 in.) from the bottom lip of the transfer filler plug hole.

      Note:
      

      • Insufficient or excessive amounts of the oil may cause a malfunction.

      • Make sure that the vehicle remains level when performing the inspection.

   3. If addition of transfer oil is necessary, perform the following procedures.

      
      

      1. Add oil so that the oil level is between 0 to 5.0 mm (0 to 0.196 in.) from the bottom lip of the case plug (for filler) hole.

         Oil grade
         Toyota Genuine Transfer gear oil LL 80 or equivalent
         Standard capacity
         0.7 liters (0.7 US qts, 0.6 Imp. qts)

   4. When the oil level is too low, check for oil leakage.

   5. Using a 10 mm socket hexagon wrench, install a new transfer filler plug gasket and the transfer filler plug.

      49 N*m

      500 kgf*cm

      36 ft.*lbf