SHIFT CONTROL ACTUATOR REMOVAL

PROCEDURE


  1. AIR SUSPENSION CONTROL PROHIBITED (w/ Air Suspension)

    Click here

  2. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY

    Click here

  3. SUPPORT HYBRID VEHICLE TRANSMISSION ASSEMBLY


    1. B004TLO

      Using a transmission jack, support the hybrid vehicle transmission assembly.

      Note

      Set the engine rear mounting member on the transmission jack to support the hybrid vehicle transmission assembly.

  4. REMOVE SHIFT CONTROL ACTUATOR ASSEMBLY

    Note

    If the shift control actuator assembly is removed, replace the shift control actuator seal.


    1. B004TBM

      Remove the 6 bolts from the engine rear mounting member.

    2. B004Y0PC01
      B004RMI Tilt Slightly

      Slightly tilt the hybrid vehicle transmission assembly.

      Note

      Tilt while paying attention to the wire harnesses.

    3. B004TNM

      Disconnect the 2 connectors and detach the clamp.

    4. B004TQRC01
      B004SZX Bolt
      B004UK4 Nut and Spring Washer

      Remove the nut, spring washer and 2 bolts and disconnect the No. 2 parking lock release cable assembly from the shift control actuator assembly.

    5. B004TRI

      Remove the 3 bolts and shift control actuator assembly from the hybrid vehicle transmission assembly.

      Tech Tips

      As the position of the shift control actuator assembly is detected automatically, initialization is not necessary after disconnecting and reconnecting the cable to the negative (-) auxiliary battery terminal.

    6. B004T9U

      Remove the bolt and bracket from the shift control actuator assembly.

    7. B004XJ8C02
      *a Protective Tape

      Using a screwdriver with its tip wrapped with protective tape, remove the shift control actuator seal from the hybrid vehicle transmission assembly.

      Note

      Be careful not to damage the hybrid vehicle transmission assembly.

      Tech Tips

      Tape the screwdriver tip before use.