ELECTRONIC SHIFT LEVER SYSTEM "P" Position Switch Circuit

PROCEDURE


  1. CHECK DTC OUTPUT (HYBRID CONTROL)


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Depress the brake pedal and move the shift lever to select neutral (N).

    4. Push the P position switch (shift position indicator) to select park (P).

    5. Jiggle the connectors and wire harness that connect the P position switch (shift position indicator) to the P1 terminal of the shift control ECU up and down, and left and right.

    6. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.


      Powertrain > Hybrid Control > Trouble Codes

    7. Check for DTCs.

      Result
      Result Proceed to
      None of the DTCs are output. A
      Any of the DTCs are output. B

    8. Turn the power switch off.


    B

    GO TO DTC CHART Click here

    A

  2. CHECK DIAGNOSIS RELATED INFORMATION (HYBRID CONTROL)


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Powertrain / Hybrid Control / Utility / Diagnosis Related Information.


      Powertrain > Hybrid Control > Utility
      Tester Display
      Diagnosis Related Information

    5. Check for diagnosis related information.

      Result
      Result Proceed to
      No diagnosis related information is output. A
      The diagnosis related information in the table below is output. B
      Diagnosis Related Information
      P085011
      P085015

    6. Turn the engine switch off.


    A

    CHECK FOR INTERMITTENT PROBLEMS Click here

    B

  3. CHECK CONNECTOR CONNECTION CONDITION (P POSITION SWITCH (SHIFT POSITION INDICATOR) CONNECTOR)


    1. Check the connector connections and contact pressure of the relevant terminals for the P position switch (shift position indicator) connector.

      Click here

      B004VNLC01
      *A for LHD *B for RHD
      OK
      The connector is connected securely and there are no contact pressure problems.
      Result
      Proceed to
      OK
      NG

    NG

    CONNECT SECURELY

    OK

  4. CHECK CONNECTOR CONNECTION CONDITION (SHIFT CONTROL ECU CONNECTOR)


    1. Check the connector connections and contact pressure of the relevant terminals for the shift control ECU connectors.

      Click here

      B004UMOC02
      *A for LHD *B for RHD
      OK
      The connectors are connected securely and there are no contact pressure problems.
      Result
      Proceed to
      OK
      NG

    NG

    CONNECT SECURELY

    OK

  5. CHECK HARNESS AND CONNECTOR (SHIFT CONTROL ECU - P POSITION SWITCH (SHIFT POSITION INDICATOR))


    1. Disconnect the G82 shift control ECU connector.

    2. Disconnect the G46 P position switch (shift position indicator) connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance (Check for Open)
      Tester Connection Condition Specified Condition
      G82-10 (P1) - G46-14 (S) Always Below 1 Ω
      Standard Resistance (Check for Short)
      Tester Connection Condition Specified Condition
      G82-10 (P1) or G46-14 (S) - Body ground and other terminals Always 10 kΩ or higher

    4. Reconnect the G46 P position switch (shift position indicator) connector.

    5. Reconnect the G82 shift control ECU connector.

      Result
      Proceed to
      OK
      NG

    OK

    CHECK FOR INTERMITTENT PROBLEMS Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR