Click here

SHIFT CONTROL ACTUATOR INSTALLATION

Click here
Click here Click here

PROCEDURE


  1. Click here

    INSTALL SHIFT CONTROL ACTUATOR ASSEMBLY

    Note:

    If the shift control actuator assembly is removed, replace the shift control actuator seal.


    1. Apply ATF WS around the outside edge of the case press-fit surface of the hybrid vehicle transmission assembly.

    2. Coat the lip of a new shift control actuator seal with a small amount of MP grease.

    3. B004VL7C03
      *a 6.5 to 7.3 mm (0.256 to 0.287 in.)

      Using SST and hammer, install the shift control actuator seal to the hybrid vehicle transmission assembly.

      09350-30020 09350-07110
      Shift Control Actuator Seal Installation Depth
      6.5 to 7.3 mm (0.256 to 0.287 in.)
      Note:

      Install the shift control actuator seal so that the white marking faces the outside of the hybrid vehicle transmission assembly.

    4. B004T9U

      Install the bracket to the shift control actuator assembly with the bolt.

      8.0 N*m 82 kgf*cm 71 in.*lbf
    5. B004S3HC01
      B004SZX Bolt A
      B004UK4 Bolt B

      Install the shift control actuator assembly to the hybrid vehicle transmission assembly with the 3 bolts.

      17.5 N*m 178 kgf*cm 13 ft.*lbf
      Item Length
      Bolt A 22 mm (0.866 in.)
      Bolt B 40 mm (1.57 in.)
      Note:

      Clean and degrease the threads of the hybrid vehicle transmission assembly side bolt holes.

      Tip:

      As the position of the shift control actuator assembly is detected automatically, initialization is not necessary after disconnecting and reconnecting the cable to the negative (-) auxiliary battery terminal.

    6. B004TQRC01
      B004SZX Bolt
      B004UK4 Nut and Spring Washer

      Connect the No. 2 parking lock release cable assembly to the shift control actuator assembly with the nut, spring washer and 2 bolts.

      for bolt
      8.0 N*m 82 kgf*cm 71 in.*lbf
      for nut
      12.7 N*m 130 kgf*cm 9 ft.*lbf
    7. B004TNM

      Connect the 2 connectors and attach the clamp.

    8. Raise the hybrid vehicle transmission assembly to a position where the engine rear mounting member bolt can be installed.

    9. B004Y3J

      Install the 6 bolts to the engine rear mounting member.

      34.7 N*m 354 kgf*cm 26 ft.*lbf

    10. Remove the transmission jack.

  2. Click here

    INSTALL PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY

    Click here