VALVE BODY ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the transmission valve body assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link

  • Transmission valve body assembly

  • Solenoid valve (SL1, SL2, SL3, SL4)

 Drive learning

  • Large shift shock

  • Deterioration of fuel efficiency

Click here

PROCEDURE


  1. AIR SUSPENSION CONTROL PROHIBITED (w/ Air Suspension)

    Click here

  2. REMOVE TRANSMISSION UNDER COVER

    Click here

  3. DRAIN TRANSMISSION FLUID

    Click here

  4. REMOVE TRANSMISSION OIL PAN SUB-ASSEMBLY

    Click here

  5. REMOVE OIL STRAINER ASSEMBLY

    Click here

  6. DISCONNECT TRANSMISSION WIRE


    1. B004WEEC02
      *1 Temperature Sensor
      *2 Lock Plate

      Remove the bolt and lock plate and disconnect the temperature sensor from the transmission valve body assembly.

    2. B004S6H

      Remove the O-ring from the temperature sensor.

    3. B004WTR

      Detach the wire harness clamp.

    4. Disconnect the 7 connectors from the transmission valve body assembly.

  7. REMOVE TRANSMISSION VALVE BODY ASSEMBLY


    1. B004YOC

      Remove the 15 bolts and transmission valve body assembly.

    2. B004UBG

      Remove the 3 gaskets from the transmission case.