Click here

ELECTRONIC SHIFT LEVER SYSTEM UTILITY

Click here
Click here
Click here

  1. ALL READINESS

    Tip:

    • With "All Readiness", you can use the GTS to check whether the DTC judgment has been completed.

    • Perform the "All Readiness" check after simulating malfunction symptoms or when performing validation after finishing repairs.


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the GTS on.

    4. Clear the DTCs even if no DTCs are stored.


      1. Powertrain > Hybrid Control > Clear DTCs


    5. Turn the power switch off and wait for at least 30 seconds.

    6. Turn the power switch on (IG).

    7. Turn the GTS on.

    8. Perform the DTC confirmation driving pattern to run the DTC judgment.

    9. Enter the following menus: Powertrain / Hybrid Control / Utility / All Readiness.


      1. Powertrain > Hybrid Control > Utility
        Tester Display
        All Readiness




    10. Input the DTCs to be confirmed.

    11. Check the DTC judgment result.

      GTS Display Description
      NORMAL

      • DTC judgment completed

      • System normal
      ABNORMAL

      • DTC judgment completed

      • System abnormal
      INCOMPLETE

      • DTC judgment not completed

      • Perform the driving pattern after confirming DTC enabling conditions

      If the judgment result shows INCOMPLETE, perform the DTC confirmation driving pattern again.

    12. Turn the power switch off.

  2. CHECK FOR DIAGNOSIS RELATED INFORMATION


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Powertrain / Hybrid Control / Utility / Diagnosis Related Information.


      1. Powertrain > Hybrid Control > Utility
        Tester Display
        Diagnosis Related Information




    5. Check the diagnosis related information and freeze frame data, and then write them down.

  3. Tip:

    Clearing the DTCs will also clear the diagnosis related information.

    CLEAR DIAGNOSIS RELATED INFORMATION


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Powertrain / Hybrid Control / Clear DTCs.


      1. Powertrain > Hybrid Control > Clear DTCs


    5. Clear the diagnosis related information and freeze frame data.