ROAD SIGN ASSIST SYSTEM(for Stereo Camera Type) DATA LIST / ACTIVE TEST


  1. DATA LIST

    Note

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

    Tech Tips

    Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Road Sign Assist / Data List.

    5. Read the Data List according to the display on the GTS.


      Body Electrical > Road Sign Assist > Data List
      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      Total Distance Traveled Total Distance Traveled 0 to 16777215 - -
      Total Distance Traveled - Unit Total Distance Traveled - Unit km or mile - -
      Traffic Sign Estimated Speed Unit Unit of estimated speed of traffic sign Unconfirmed, kph or mph

      Unconfirmed: Unconfirmed

      kph: km/h

      mph: mph

      		 -
      Traffic Sign Estimated Traffic Division Estimated direction of traffic stored in the object recognition camera Unconfirmed, Right-hand traffic or Left-hand traffic

      Unconfirmed: Unconfirmed

      Right-hand traffic: Right-hand traffic

      Left-hand traffic: Left-hand traffic

      		 -
      RSA Navigation Fusion Control RSA fusion control operation status OFF or ON

      OFF: Operating

      ON: Not operating

      		 When RSA fusion control is operating, road signs recognized by the object recognition camera are checked against information in the navigation system.