LANE CONTROL SYSTEM(for Stereo Camera Type) DATA LIST / ACTIVE TEST


  1. DATA LIST

    Note

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

    Tech Tips

    Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Chassis / Lane Control / Data List.

    5. Read the Data List according to the display on the GTS.


      Chassis > Lane Control
      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      Total Distance Traveled Total Distance Traveled 0 to 16777215 - -
      Total Distance Traveled - Unit Total Distance Traveled - Unit km or mile - -
      LDA Control Control status of lane control system Prohibit or Permit

      Prohibit: Control prohibited

      Permit: Control permitted

      		 -
      Turn Switch (Right) Turn signal switch (right) status OFF or ON

      ON: Turn signal light switch on (right)

      OFF: Turn signal light switch off

      		 -
      Turn Switch (Left) Turn signal switch (left) status OFF or ON

      ON: Turn signal light switch on (left)

      OFF: Turn signal light switch off

      		 -
      Vehicle Information (2WD/4WD) Vehicle information (drivetrain) stored in object recognition camera 2WD, 4WD or Unknown - -
      Vehicle Information (Conv/HV) Vehicle information (conventional/hybrid) stored in object recognition camera Conv, HV or Unknown - -

  2. ACTIVE TEST

    Tech Tips

    Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Chassis / Lane Control / Active Test.

    5. Perform Active Test according to the display on the GTS.

      Tech Tips

      The power switch must be turned on (IG) to proceed with the Active Test using the GTS.


      Chassis > Lane Control > Active Test
      Tester Display Measurement Item Control Range Diagnostic Note
      Steering Wheel Vibration Vibrates the steering wheel assembly ON/OFF Confirm that the vehicle is stopped with the power switch on (IG).
      Meter Buzzer Sounds the LTA Buzzer (meter buzzer) ON/OFF Confirm that the vehicle is stopped with the power switch on (IG).

    6. Enter the following menus: Body Electrical / Combination Meter / Active Test.

    7. Perform Active Test according to the display on the GTS.

      Tech Tips

      The power switch must be turned on (IG) to proceed with the Active Test using the GTS.


      Body Electrical > Combination Meter > Active Test
      Tester Display Measurement Item Control Range Diagnostic Note
      Meter Display (All) Multi-information display ON Confirm that the vehicle is stopped with the power switch on (IG).