PROCEDURE
- Click here
ADJUST STANDARD VEHICLE HEIGHT
- Click here
INSPECT VEHICLE HEIGHT
-
Inspect the vehicle height.
-
Perform automatic vehicle height adjustment.
Note:The possible vehicle height automatic adjustment value is 25 mm. If the "Height Adjust value + (Standard value - Measurement value - After Height Adjust value)" is 25 mm or more, first perform the standard vehicle height adjustment (height control link adjustment).
-
- Click here
ADJUST HEIGHT CONTROL SENSOR LINK SUB-ASSEMBLY (for Front)
Note:
-
First adjust the height control sensor link that has the highest deviation from the standard value.
-
If the deviation of the front and rear link is the same, adjust the front link first.
-
Loosen the 2 lock nuts on the height control sensor link.
-
Turn the bolt of the height control sensor link to adjust the length.
Tip:
-
If raising the vehicle height, lengthen the link.
-
If lowering the vehicle height, shorten the link.
-
Turning the bolt of the height control sensor link 1 revolution changes the vehicle height by about 6.9 mm (0.272 in.).
-
-
Check if the height control sensor link dimension shown in the illustration is less than the maximum value.
Maximum dimension 18 mm (0.709 in.) -
Tighten the lock nuts.
5.4 N*m 55 kgf*cm 48 in.*lbf Note:Make sure the ball joint and bracket are parallel when tightening the lock nuts.
-
- Click here
ADJUST HEIGHT CONTROL SENSOR LINK SUB-ASSEMBLY (for Rear)
-
*a Adjustment Range Adjust the rear vehicle height by moving the installation position of the link on the lower arm.
5.4 N*m 55 kgf*cm 48 in.*lbf Tip:When the link is moved 1.0 mm (0.0394 in.), the vehicle height is adjusted by about 1.5 mm (0.0591 in.).
-
Perform vehicle height offset calibration once again.
-
Inspect the vehicle height once again.
-
- Click here
INSPECT WHEEL ALIGNMENT
-
for Front 2WD:
-
for Front AWD:
-
for Rear:
-
- Click here
ADJUST HEADLIGHT ASSEMBLY