FRONT BUMPER COMPONENTS
ILLUSTRATION
| *1 | NEGATIVE AUXILIARY BATTERY TERMINAL | *2 | NO. 2 DECK BOARD |
 |
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) | - | - |
ILLUSTRATION
| *1 | ENGINE ROOM SIDE COVER LH | *2 | FRONT BUMPER COVER |
| *3 | LOWER RADIATOR AIR DEFLECTOR | *4 | RADIATOR SUPPORT TO FRAME SEAL RH |
| *5 | FRONT SIDE BUMPER RETAINER LH | *6 | FRONT SIDE BUMPER RETAINER RH |
 |
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *1 | FRONT CENTER ULTRASONIC SENSOR | *2 | FRONT CORNER ULTRASONIC SENSOR |
| *3 | FRONT CORNER ULTRASONIC SENSOR RETAINER | *4 | HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY LH |
| *5 | HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY RH | *6 | HEADLIGHT WASHER COVER |
| *7 | NO. 2 WASHER BRACKET | *8 | NO. 4 ENGINE ROOM WIRE |
| *9 | ULTRASONIC SENSOR CLIP | *10 | WASHER BRACKET |
| ● | Non-reusable part | - | - |
ILLUSTRATION
| *A | for Type A | *B | for Type B |
| *C | for Type C | - | - |
| *1 | FRONT BUMPER EXTENTION MOUNTING BRACKET | *2 | FRONT BUMPER GARNISH |
| *3 | FRONT BUMPER GARNISH LH | *4 | FRONT BUMPER HOLE COVER LH |
| *5 | FRONT BUMPER MOUNTING BRACKET | *6 | FRONT FENDER LINER RETAINER |
| *7 | FRONT TURN SIGNAL LIGHT ASSEMBLY LH | *8 | FRONT TURN SIGNAL LIGHT ASSEMBLY RH |
| *9 | LOWER SIDE RADIATOR GRILLE LH | *10 | LOWER SIDE RADIATOR GRILLE RH |
| *11 | NO. 1 FRONT BUMPER SIDE SUPPORT LH | *12 | NO. 1 FRONT BUMPER SIDE SUPPORT RH |
| *13 | NO. 1 MOULDING TAPE | *14 | NO. 2 MOULDING TAPE |
| *15 | RADIATOR GRILLE SUB-ASSEMBLY | - | - |
| ● | Non-reusable part | - | - |
ILLUSTRATION
| *A | w/ Dynamic Radar Cruise Control System | - | - |
| *1 | LOWER RADIATOR GRILLE | *2 | MILLIMETER WAVE RADAR SENSOR ASSEMBLY |
| *3 | NO. 2 RADIATOR GRILLE MOULDING | *4 | RADIATOR GRILLE (OR FRONT PANEL) EMBLEM |
| *5 | RADIATOR GRILLE MOULDING | *6 | UPPER RADIATOR GRILLE |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *1 | FRONT BUMPER ENERGY ABSORBER | *2 | FRONT BUMPER REINFORCEMENT SUB-ASSEMBLY |
| *3 | HEADLIGHT CLEANER HOSE | *4 | LOWER ARM BRACKET BRACE SUB-ASSEMBLY LH |
| *5 | LOWER ARM BRACKET BRACE SUB-ASSEMBLY RH | *6 | NO. 2 FRONT BUMPER MOUNTING BRACKET |
| *7 | PEDESTRIAN DETECTION CHAMBER ASSEMBLY | - | - |
| |
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) | |
N*m (kgf*cm, ft.*lbf): Specified torque |
| ● | Non-reusable part | - | - |