BACK-UP LIGHT ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

Tech Tips

If the bumper is damaged, there is a possibility that the installation area of the blind spot monitor sensor may be deformed and the blind spot monitor system may not operate correctly, so visually inspect the blind spot monitor sensor installation area (frame, stud bolt) to make sure it is not dented or bent.

Click here

If the visual inspection finds a problem, check the installation condition of the blind spot monitor sensor, and adjust the installation position of the blind spot monitor sensor as necessary.

PROCEDURE


  1. REMOVE REAR BUMPER ASSEMBLY

    Click here

  2. REMOVE BACK-UP LIGHT ASSEMBLY


    1. B004AV2C01
      B004C4F Screw
      B004ANI Connector
      B004CG0 Double-sided Tape Application Area

      Disconnect the connector.

    2. Remove the 2 screws.

    3. Remove the 2 pieces of double-sided tape and the back-up light assembly.