FUEL LID LOCK CONTROL CABLE ASSEMBLY INSTALLATION

PROCEDURE

1. INSTALL FUEL LID WITH MOTOR LOCK ASSEMBLY

   Note

   If the fuel lid with motor lock assembly has been struck or dropped, replace it with a new one.

   
   

   1. 

      Install in this Direction

      Connect the connector.

   2. Push the shaft, attach the claw to install the fuel lid with motor lock assembly.

      Note

      Push it until hear a lock sound.

   3. 

      Attach the cable clamps.

   4. Install the cable lever for the hook fastener.

   5. 

      Put back the room partition panel insulator.

2. INSTALL QUARTER TRIM PANEL ASSEMBLY LH

   Click here

3. INSTALL FRONT SEAT OUTER BELT ASSEMBLY LH (FLOOR ANCHOR)

   Click here

4. INSTALL OUTER LAP BELT ANCHOR COVER

   Click here

5. INSTALL FRONT DOOR SCUFF PLATE LH

   Click here

6. INSTALL REAR NO. 1 SEAT INNER BELT ASSEMBLY LH

   Click here

7. INSTALL QUARTER INSIDE TRIM BOARD LH

   Click here

8. INSTALL REAR SEATBACK ASSEMBLY LH

   Click here

9. INSTALL REAR SEATBACK COVER

   Click here

10. INSTALL REAR SEAT SIDE GARNISH

    Click here

11. INSTALL REAR SEAT CUSHION LOCK HOOK

    Click here

12. INSTALL REAR SEAT CUSHION ASSEMBLY

    Click here

13. INSTALL FRONT SEAT ASSEMBLY LH

    Click here

14. INITIALIZATION OF SEAT ECU

    Click here

15. INSPECT FRONT SEAT ASSEMBLY

    Click here

16. INSPECT CLIMATE CONTROL SEAT SYSTEM (w/ Seat Heater System)

    Click here

17. CHECK SRS WARNING LIGHT

    Click here