FLUSH HANDLE SYSTEM Improper Operation

DESCRIPTION


WIRING DIAGRAM

Click here

CAUTION / NOTICE / HINT

Note


  • If the vehicle or vehicle controls are operated (for example, during initial inspection when the vehicle is brought in for repair) before operation history has been read out and saved, the operation history information could be lost.

  • The function "Read operation history" uses the current system time setting inside the GTS and the time counter inside the controlling ECU to calculate the timings shown in the operation history. For this reason, before reading out the operation history, first make sure that the GTS system clock is accurately set to the current time.

PROCEDURE


  1. CHECK FLUSH HANDLE OPERATION HISTORY


    1. Use the GTS to check the door glass operation history around the time that the malfunction reported by the customer occurred, based on the contents of the customer interview and the last recorded door outside handle operation history around the time that the problem is reported to have occurred.


      1. On the GTS screen, enter the following menus: Body Electrical / Main Body / Utility / Operation History Analysis. According to the display on the GTS, read the operation history.

        Click here

      2. Check that there is door outside handle operation history as reported by the customer.

        Click here

        Tech Tips

        Based on the displayed operation history, perform vehicle-side inspection, and perform repairs if a problem is found. If the vehicle has no malfunction, interview the customer about possible causes such as "the driver" and "environmental / other than the driver".

      Result
      Result Proceed to
      There is no operational history around the time that the customer reported the malfunction to have occurred A
      There is operational history around the time that the customer reported the malfunction to have occurred, and by following the instructions to inspect the relevant areas, the malfunction was identified B
      There is operational history around the time that the customer reported the malfunction to have occurred, but the malfunction could not be identified even by following the instructions to inspect the relevant areas C

    B
    C
    A
  2. CHECK FLUSH HANDLE SYSTEM


    1. Check the flush handle system operation.

      Click here

      OK
      Flush handle system normally.
      Result
      Proceed to
      OK
      NG

    NG
    OK
  3. CHECK POWER DOOR LOCK CONTROL SYSTEM


    1. Check the power door lock control system operation.

      Click here

      OK
      Power door lock control system is normally.
      Result
      Proceed to
      OK
      NG

    NG
    OK
  4. CHECK WIRELESS DOOR LOCK CONTROL SYSTEM


    1. Check the wireless door lock control system operation.

      Click here

      OK
      Wireless door lock control system operates normally.
      Result
      Proceed to
      OK
      NG

    NG
    OK
  5. CHECK ENTRY AND START SYSTEM (for Entry Function)


    1. Check the entry and start system (for Entry Function) operation.

      Click here

      OK
      Entry and start system (for Entry Function) operates normally.
      Result
      Proceed to
      OK
      NG

    NG
    OK
  6. PERFORM TROUBLESHOOTING BASED ON MALFUNCTION SYMPTOM


    1. Perform troubleshooting based on the malfunction symptoms.

      OK
      Malfunction was identified.
      Result
      Proceed to
      OK
      NG

    OK
    NG
  7. INTERVIEW THE CUSTOMER


    1. If the phenomenon could not be confirmed or reproduced, after explaining this to the customer, also explain the history of input signals involving systems such as the multiplex network master switch assembly and electronic key (electrical key transmitter sub-assembly) for the relevant date/time in the operational history.

      Click here

      OK
      Cause was identified
      Result
      Proceed to
      OK
      NG

    OK
    NG