ROOM TEMPERATURE SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the cooler thermistor (room temperature sensor) removal/installation are shown below.

Necessary Procedures after parts removed / installed / replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point LKA/LDA system

Click here

Pre-collision system
Parking assist monitor system

Click here

Steering sensor zero point calibration Variable gear ratio steering system

Click here

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

B004CGW

Click here

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET

    Click here

  2. REMOVE COOLER THERMISTOR (ROOM TEMPERATURE SENSOR)


    1. B004AZL

      Detach the claw and remove the cooler thermistor (room temperature sensor) from the instrument panel safety pad sub-assembly.

    2. B004BTSC01
      B004B1M Remove in this Direction

      Pull out the cooler thermistor (room temperature sensor) through the gap as shown in the illustration.

    3. B004CURC01
      B004C4F Aspirator
      B004ANI Connector

      Disconnect the Aspirator and connector and remove the cooler thermistor (room temperature sensor).