PTC HEATER ASSEMBLY INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. INSTALL QUICK HEATER ASSEMBLY

    Note

    Do not hold the quick heater assembly by the element or fan. Also, do not damage the quick heater assembly. (Foul odors may occur due to oil adhering to the quick heater assembly.)


    1. B000OLSC01
      *a Matchmarks
      *b Heater Case Fitting Surface
      *c Quick Heater Claw
      B004B1M Insert Straight

      Align the matchmark on the quick heater assembly with the matchmark on the heater case as shown in the illustration, insert the quick heater assembly into the heater case and attach the claw.

      Note

      Check that the heights of the claw fitting surface on the heater case and the claw of the quick heater assembly are aligned.

      Tech Tips

      If the claw of the quick heater assembly are damaged, install the screw.

    2. B000S7MC01
      B004C4F White Connector
      B004ANI Blue Connector
      B004BQJ Screw

      Install the quick heater assembly with the screw.

    3. Connect the 2 connectors.

      Note

      Connect the connectors so that the white connector is on the top side.

  2. INSTALL STEERING COLUMN ASSEMBLY

    Click here

  3. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Click here

  4. INSTALL NO. 2 DECK BOARD

    Click here

  5. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  6. INSPECT SRS WARNING LIGHT

    Click here

  7. CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM


    1. Reset the auto tilt away function setting to the previous condition by changing the customize parameter.

      Click here