REAR SEAT OUTER BELT ASSEMBLY INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. INSPECT REAR NO. 1 SEAT OUTER BELT ASSEMBLY

    Click here

  2. INSTALL REAR NO. 1 SEAT OUTER BELT ASSEMBLY LH


    1. B004A7KN01

      Attach the guide and temporarily install the rear No. 1 seat outer belt assembly LH.

    2. Install the 2 bolts.

      Torque:
      Bolt A
      12.5 N*m  { 127 kgf*cm, 9 ft.*lbf }
      Bolt B
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }
    3. B004ASKC01
      *a Locking Button
      *b Lock

      Connect the pretensioner connector and lock the locking button as shown in the illustration.

      Note


      • When handling the pretensioner connector, take care not to damage the pretensioner wire harness.

      • Securely lock the locking button.

  3. INSTALL REAR NO. 1 SEAT OUTER BELT ASSEMBLY RH

    Tech Tips

    Use the same procedure described for the LH side.

  4. INSTALL ROOM PARTITION PANEL INSULATOR


    1. B004AMT

      Install the room partition panel insulator with the 4 clips.

  5. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY

    Click here

  6. INSTALL REAR NO. 1 SEAT OUTER BELT ASSEMBLY LH(FLOOR ANCHOR)


    1. Check that the rear No. 1 seat outer belt assembly LH is not twisted.

    2. B004C7RC01
      *a Protruding Part

      Install the floor anchor of the rear No. 1 seat outer belt assembly LH with the bolt.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

      Note

      Do not allow the floor anchor of the rear No. 1 seat outer belt assembly LH to overlap the protruding part.

    3. Check that the ELR locks.


      1. With the front seat outer belt assembly installed to the vehicle, check that the belt locks when it is pulled out quickly.

  7. INSTALL REAR NO. 1 SEAT OUTER BELT ASSEMBLY RH(FLOOR ANCHOR)

    Tech Tips

    Use the same procedure described for the LH side.

  8. INSTALL NO. 3 SPEAKER ASSEMBLY WITH BOX

    Click here

  9. INSTALL CHILD RESTRAINT SEAT TETHER ANCHOR COVER

    Click here

  10. INSTALL INNER ROOF SIDE GARNISH ASSEMBLY LH

    Click here

  11. INSTALL INNER ROOF SIDE GARNISH ASSEMBLY RH

    Tech Tips

    Use the same procedure described for the LH side.

  12. INSTALL ROOF SIDE RAIL GARNISH ASSEMBLY LH

    Click here

  13. INSTALL ROOF SIDE RAIL GARNISH ASSEMBLY RH

    Tech Tips

    Use the same procedure described for the LH side.

  14. INSTALL INNER ROOF SIDE GARNISH LH

    Click here

  15. INSTALL INNER ROOF SIDE GARNISH RH

    Tech Tips

    Use the same procedure described for the LH side.

  16. INSTALL CENTER PILLAR GARNISH ASSEMBLY LH

    Click here

  17. INSTALL CENTER PILLAR GARNISH ASSEMBLY RH

    Tech Tips

    Use the same procedure described for the LH side.

  18. INSTALL QUARTER TRIM PANEL ASSEMBLY LH

    Click here

  19. INSTALL QUARTER TRIM PANEL ASSEMBLY RH

    Tech Tips

    Use the same procedure described for the LH side.

  20. INSTALL FRONT SEAT OUTER BELT ASSEMBLY LH(FLOOR ANCHOR)

    Click here

  21. INSTALL FRONT SEAT OUTER BELT ASSEMBLY RH(FLOOR ANCHOR)

    Tech Tips

    Use the same procedure described for the LH side.

  22. INSTALL OUTER LAP BELT ANCHOR COVER

    Tech Tips

    Use the same procedure for the other side.


    1. B004A5KC02
      *a Guide A
      *b Guide B
      B004B1M Install in this Direction (1)
      B004CNL Install in this Direction (2)

      Slide in the installation direction (1) shown in the illustration to attach the guide B.

    2. Push in the installation direction (2) shown in the illustration to attach the guide A and install the outer lap belt anchor cover.

  23. INSTALL FRONT DOOR SCUFF PLATE LH

    Click here

  24. INSTALL FRONT DOOR SCUFF PLATE RH

    Tech Tips

    Use the same procedure described for the LH side.

  25. INSTALL REAR NO. 1 SEAT INNER BELT ASSEMBLY LH

    Click here

  26. INSTALL REAR SEAT INNER BELT ASSEMBLY RH

    Tech Tips

    Use the same procedure described for the rear No. 1 seat inner belt assembly LH.

  27. INSTALL QUARTER INSIDE TRIM BOARD LH

    Click here

  28. INSTALL QUARTER INSIDE TRIM BOARD RH

    Tech Tips

    Use the same procedure described for the LH side.

  29. INSTALL REAR SEATBACK ASSEMBLY LH

    Click here

  30. INSTALL REAR SEATBACK ASSEMBLY RH

    Tech Tips

    Use the same procedure described for the LH side.

  31. INSTALL REAR SEATBACK COVER

    Click here

  32. INSTALL REAR SEAT SIDE GARNISH

    Click here

  33. INSTALL REAR SEAT CUSHION LOCK HOOK

    Click here

  34. INSTALL REAR SEAT CUSHION ASSEMBLY

    Click here

  35. INSTALL FRONT SEAT ASSEMBLY LH

    Click here

  36. INSTALL FRONT SEAT ASSEMBLY RH

    Tech Tips

    Use the same procedure described for the LH side.

  37. INITIALIZATION OF SEAT ECU

    Click here

  38. INSPECT SEAT BELT WARNING SYSTEM

    Click here

  39. INSPECT SRS WARNING LIGHT

    Click here